Orange Pi Plus 2E

by Shenzhen Xunlong Software CO.,Limited

Image of Board

What’s Orange Pi Plus 2E？ It’s an open-source single-board computer. It can run Android 4.4 , Ubuntu, Debian Image, it uses the AllWinner H3 SoC, and has 2GB DDR3 SDRAM

What can I do with Orange Pi Plus 2E? Build… A computer A wireless server Games Music and sounds HD video A speaker Android Scratch Pretty much anything else, because Orange Pi Plus 2E is open source

Who’s it for? Orange Pi Plus 2E is for anyone who wants to start creating with technology – not just consuming it. It’s a simple, fun, useful tool that you can use to start taking control of the world around you.

  • H3 Quad-core Cortex-A7 H.265/HEVC 4K
  • Mali400MP2 GPU @600MHz
  • Supports OpenGL ES 2.0
  • 2GB DDR3 (shared with GPU)
  • 16GB EMMC Flash
  • TF card (Max. 32GB) / MMC card slot
  • 10/100M Ethernet RJ45
  • WiFi - Realtek RTL8189ETV, IEEE 802.11 b/g/n
  • A CSI input connector Camera
  • Supports 8-bit YUV422 CMOS sensor interface
  • Supports CCIR656 protocol for NTSC and PAL
  • Supports SM pixel camera sensor
  • Supports video capture solution up to 1080p@30fps
  • MIC
  • Supports HDMI output with HDCP
  • Supports HDMI CEC
  • Supports HDMI 30 function
  • Integrated CVBS
  • Supports simultaneous output of HDMI and CVBS
  • v3.5 mm Jack and HDMI
  • vDC input can supply power, but USB OTG input don’t supply power
  • Three USB 2.0 HOST, one USB 2.0 OTG
  • Power Button(SW4), Recovery Button(SW3), Uboot Button(SW2)
  • 40 Pins Header
  • GPIO(1x3) pin
  • UART, ground.
  • Power led & Status led
  • IR input, POWER
  • Android Ubuntu, Debian Image

Purchase

Contribute

Have some info to add for this board? Edit the source for this page here.

Adafruit Blinka Installation

We use a special library called adafruit_blinka (named after Blinka, the CircuitPython mascot) to provide the layer that translates the CircuitPython hardware API to whatever library the Linux board provides.

For example, on Raspberry Pi we use the python RPi.GPIO library. For any I2C interfacing we'll use ioctl messages to the /dev/i2c device. For SPI we'll use the spidev python library, etc. These details don't matter so much because they all happen underneath the adafruit_blinka layer.